Saving Point 1.
All 50ml Cartridge can be connected
Saving Point 2.
Innovative solution to save waste material in the mixing tip
-Make sure that the mixing tip does not cross the direction of the catalyst and the base.
|❶ Fasten the 50ml cartridge to the Mixing gun.||❷ Connect 50ml cartridge to Impression Saver connector.||❸ Bleed a small amount of material from the cartridge onto mixing pad and discard.|
(Note. until the base paste and catalyst flow out in an even)
|❹ Connect Impression saver 6ml syringe to other side of connector.||❺ Check both side of connector if the 50ml cartridge and 6ml syringe are correctly connected.||❻ Press the cartridge mixing gun and transfer the impression material to the 6ml syringe.|
|❼ Fasten the filled 6ml syringe to the syringe mixing gun.|
(Note. Marked side should facing up, when fasten to the mixing gun.)
|❽ Bleed a small amount of material from the syringe onto mixing pad and discard.||❾ Connect mixing tip and syringe material around prepared tooth.|
❿ Remove the mixing tip and close the cap after use if impression material is left, and store the syringe on a blister or dedicated cradle. Make sure that the mixing tip does not cross the direction of the catalyst and the base.
(Note. Make sure that the mixing tip does not cross the direction of the catalyst and the base.)
Impression Saver Starter Kit
5 x Syringes
10 x Connectors
100 x Mixing Tips
Impression Saver Economic Syringe Pack
|Connector for Impression Saver||Mixing Tip for Impression Saver|
10 x Connectors
20 x Connectors
50 Mixing Tips
100 Mixing Tips
Cradle for 6ml Syringe
Copyright Seil Global Co.,LTD All Rights Reserved.